five. In step 14, when setting up the tracks (DD) into the Wooden blocks (R), have the picket block stick out close to an inch past the edge on the tracks to the facet that will connect to the tip piece (K and The remainder). Another two blocks need to be flush with the end with the tracks that attach to the cabinet piece.Your just lately seen thin
I didn't choose to choose it aside, so I screwed them on from an angle and added a rubber band below on the list of brackets, so it latched correctly. I want I'd personally've hooked up them in action thirteen!I built all of them flush at the outset which induced the tracks not to be long ample, And so the 3rd leaf overlapped the edge with the tabl
I made all of them flush at the outset which caused the tracks to not be lengthy plenty of, Therefore the third leaf overlapped the edge on the table by about a person centimeter. Leaving that added inch (in the block sticking past the tracks) will let you thoroughly lengthen the table, add the third leaf, then drive the table shut prior to latchin
In part of phase 6, I employed among the list of brackets (II) to show FF since the mini screwdriver wouldn't suit among the cabinets. I don't think this step might be finished outside of buy, so you merely must make owing. It a little bit bent the bracket, but there must be 1 extra within the spare elements bag. In any case, it remains to be usabl
5. In stage 14, when setting up the tracks (DD) towards the Wooden blocks (R), possess the picket block adhere out roughly an inch previous the edge in the tracks to the side that will attach to the top piece (K and The remainder). The other two blocks needs to be flush with the tip of the tracks that attach to the cabinet piece.We haven't purchase